PowerMax+
Introduction
Welcome to PowerMax+, the wireless Home Security solution.
This guide provides some step by step information that will help
you get the system up and running.
Before you begin you should know that this kit is supplied with
the transmitters pre-enrolled and pre-programmed with the
most common settings. Additionally, each transmitter is labelled
with its zone or fob number on the rear plastic. Following this
guide will help you make basic conguration changes, for more
detailed information please refer to the full programming guide
included within the kit.
Finally….we have included a trouble shooting section to this
guide. BEFORE you ring the support line have a look through as
most common problems are listed here.
1) To Access the installer mode via the user menu. Press
until the display shows “User settings”, then press
and
enter the user code. Once in the user menu press
twice until
the display shows installer mode, then press
followed by
the installer code.
Default codes are :- User 1111 / Installer 9999. L
Whilst in any of the menus (user or installer) the following keys
will help you navigate the systems:-
– returns you to the start of the main menu.
– takes you back to the previous menu
– scrolls forward in the menu
– scrolls back in the menu
2) Choose a location to mount your control panel,
making sure it is at least 1m from any large metallic objects e.g.
Radiators, or RF equipment e.g. WiFi transmitters. Additionally
ensure there is access to a mains power supply and telephone
line if required.
Remove the bracket from the main control panel by undoing the
screw located at the bottom of the panel. Mark and x as required
using three xing points. Once done install the transformer,
remove the Euro plug and connect to the mains point via a 3pin
plug (not supplied) or for EN-50131 systems an unswitched fuse
spur (not supplied)
This is a professional product and is not suitable for DIY L
installation
QuickFit Kit Easy Start Guide
STOP!
Make a cup of tea, and spend the next
five minutes reading this information.
1
Keypad cover
(closed)
2
Control keys
3
Display
4
Luminous
indicators
5
Microphone
6
Built-in siren
7
Battery
compartment
cover (closed)
8
Bracket screw
P
r
e
E
n
r
o
l
l
e
d
,
P
r
e
-
P
r
o
g
r
a
m
m
e
d
,
R
e
a
d
y
t
o
I
n
s
t
a
l
l
1
2
3
4
5
6
7
8
To Next Page
Need help?
General
