Need help?Do you have a question about the Vista M1 and is the answer not in the manual?
E-STOP button provides Emergency STOP signal to LinuxCNC application.
Instruction to install driver and other files, and add lines to the .ini file.
Steps to connect the pendant via USB and start the LinuxCNC application.
Press X, Y or Z axis selection button to select an axis to jog.
Selects STEP, VELOCITY, CONTINUOUS, or CONTINUOUS RATE modes for MPG operation.
Control feed rate (F%) and spindle speed (S%) using MPG.
Utilize ZERO, START/HOLD, and STOP/REW buttons for machine control.
Activate Emergency STOP signal or exit Emergency Mode.
General| Brand | Vista |
|---|---|
| Model | M1 |
| Category | Telephone Accessories |
| Language | English |
To Next Page