What to do if Vista DVR shows 'Ping Test time out' message?
If you're getting a 'Ping Test time out' message on your Vista DVR, first verify that the DVR and your computer are on the same intranet. Also, check to ensure that no other devices on the same network are using the same IP address. Finally, confirm that the IP address, subnet mask, and gateway address settings are correct.
How to fix Vista DVR ping test fails without router?
If the ping test fails on your Vista DVR when there is no router, try connecting your PC and the DVR directly using a crossover LAN cable (usually orange).
General safety and operational guidelines to prevent damage or injury.
Recommendations for installing the unit in a suitable environment to ensure proper operation.
Illustrates a typical setup for the NVR system with connected devices.
Step-by-step instructions for installing the Hard Disk Drive inside the NVR.
Instructions on how to connect the NVR to a network for remote access.
Describes the initial power-on sequence and the easy setup process.
Configuration settings related to video and audio input from cameras.
Process for adding and configuring IP cameras to the NVR system.
Configuration parameters for recording video and audio based on various triggers.
Configuration for peripherals like storage, sensors, and PTZ control.
Basic system settings including date, time, language, and security.
Configuration of network parameters for remote access and connectivity.
Instructions on how to back up recorded data from the NVR to external storage.
Main section for configuring NVR settings remotely through the web interface.
To Next Page
General
