12
OPERATING INSTRUCTIONS
Liquids
(water, juice, yogurt)
Dry Goods (grains,
seasonings, powders)
Leafy Greens
Fruits & Veggies
Ice & Frozen
Ingredients
motor base without a container properly in place.
5. Always start with the High/Low Switch on Low ( ). Do not begin blending
on High
( )
. Switch the On/O Switch to On (|). Follow the recipe
instructions. Until you are accustomed to the blender, try to avoid over
processing.
6. Switch the High/Low Switch to Low ( ). Switch the On/Off Switch to
Off (O). Wait until the blades completely stop before removing the lid or
container from the motor base.
Loading the Container
CAUTION
To minimize splatter and before switching the On/O Switch
to the On (|) position, make sure that the High/Low Switch
is set to Low ( ) . Do not start your blender on High ( ).
Escaping steam, splashes or contents maycause burns.
To secure the contents, lock the lid and lid plug securely in
place prior to operating theblender.
1. Before you begin, look at the
control panel. Make sure the
the On/O switch is O (O)
and the High/Low Switch is
on Low ( ).
2. Load the container according
to the recipe.
3. Securely fasten the 2-part lid
to the container. Always use
the complete 2-part lid when
blending (unless the tamper is
inserted through the lid plug
opening). When blending
with hot ingredients, make
sure the lid is securely
latched.
4. With the motor o, set the
container on the motor base
by aligning it on the centering
pad. Do not attempt to put
a container on an operating
motor base or to operate a
To Next Page
Loading...
