23ENG
10. INACTIVITY OF THE MAKER
Aer using the machine, to keep it in perfect working order and prevent mould
from forming, proceed as follows.
Switch o the ice maker and unplug it from the mains power.
Empty out the ice tray. Wait for the frost inside the tray to melt completely.
Dry the inside of the ice maker. Leave the door slightly open to allow air to circulate so
that moisture build up does not form inside the tray.
For REFILL versions, empty the tank following the instructions in the section entitled
“CLEANING THE ICE MAKER.”
11. CLEANING THE ICE MAKER
Before cleaning the ice maker, make sure that it is not connected to the mains power
supply. If connected, unplug it.
EXTERIOR
Wash the ice maker exterior with lukewarm water, rinse with cold water, and dry with
a so cloth. Do not use abrasive products.
INTERIOR
Remove the ice tray and proceed to clean using warm water mixed with a little
bicarbonate of soda or vinegar. Rinse carefully and dry thoroughly using a so cloth.
Never use abrasive products, detergents or soap.
CONDENSER
The condenser I) should be cleaned at least once a year, using a vacuum cleaner or a
dry so brush.
TANK (REFILL version only)
The tank should be cleaned at least once every three months and proceeding as
follows:
• completely unscrew the screw on the front panel by turning it anticlockwise
• slide the front panel downwards for a few centimetres and remove from the front
To Next Page
Loading...
