24 ENG
• remove the tank being careful not to disturb the water hose or the power cable
• use a screwdriver and loosen the screws and remove the pump from its seating.
Clean the pump with water.
Follow these instructions in reverse order to reposition the pump in its seating and
replace the front panel, making sure that the pins on the lower n enter correctly
into the holes on the base of ice maker.
ATTENTION when cleaning the tank, be especially careful of the sharp surfaces to
be found on the condenser. The use of standard (PPE) protective gloves to prevent
accidental injuries is strongly recommended.
12. WHAT TO DO IF THE ICE MAKER DOES NOT WORK
If the problem has not been resolved aer these checks, please contact Customer
Service.
Problems Check that
The appliance does not work
it is energised
the switch is in the “I” position
the automatic circuit breaker of the electrical system is not disconnected
the plug is ecient and correctly inserted into the socket and the power outlet
works. For this verication, connect to the socket a device whose functioning is
certain
the supply cable is not interrupted
Noisy ice maker
the ice maker is on a level surface
the ice maker is not in contact with furniture that can could cause vibrations
the refrigerant circuit pipes located on the back have no contact points and
do not vibrate against the appliance
To Next Page
Loading...
