4 5
• Please ensure that the voltages of power supply you are using match with rated
working voltages before operating the machine
• The power supply should be close to the machine for convenient use
• The power supply should provide reliable protective earthing connection
• This machine must be earthed reliably so as to ensure the safety of the machine
during operation
• Only the operators of this machine should operate the electric or motion
components/controls
• Please don’t use damaged wires or sockets
• Please keep children away from touching and operating this machine
• Please do not spray water or other liquid on the machine otherwise electric shock or
machine faults could occur
• Please do not replace power cord or plugs yourself, do not put heavy objects on the
power lines as this may cause electric shocks
• During use please take care that no clothes, neckties, hair, necklaces etc are near the
machine otherwise injuries could occur
• Please don’t put burrs, sharp blades or over thick rigid materials into the two rubber
covered rollers (for example, tools, rulers and knives etc.)
• Dont cut adhesive lms directly on the surfaces of the rubber covered rollers to avoid
damage
• Please shut down this machine after laminating to avoid misuse of the machine
• At the end of the working day always gape the rollers to ensure no at spots or
distortions occur
• When you need to move this machine, please shut down the power switch and pull
out the plugs
• Please be aware of the location of the wheels during moving or operating this
machine to avoid foot injuries
• Always ensure the machine is positioned on a at and level oor
• Please shut o the power supply (pull out the power plug) when the machine isn’t
going to be used for long periods of time.
• Ambient temperature 10°C - 60°C, humidity 30% - 80%, Ideal humidity 55%
• Dust - Due to the static adherance of the lm, you should keep the environment clean, a
dust cover is provided with the machine
• Please do not keep the machines in direct sunlight
• Please do not keep the machine in or around dusty areas
• Enough space should be kept around the machine to ensure the secure and e ective ap-
plication. The minimum holding areas are 2.5m x 3m
Environmental Requirements
EM-1200 EM-1400 EM-1600
Max Laminating Width 1200mm 1400mm 1600mm
Max Laminating Thickness 25mm
Temperature of Rubber Roller Ambient temperature to 60°C
Approx Highest Line Speed 6m/min
Approx Lowest Line Speed 0.7m/min (adjusting the pressure and speeds)
Rated Working Voltage/Frequency 220V, 50Hz (100V, 60Hz)
Rate Input Power 900W 1000W 1300W
Dimensions 1790 x 650 x 1255mm 1990 x 650 x 1255mm 2190 x 650 x 1255mm
Net Weight 185kg 210kg 245kg
Speci cations
EM-1200SH EM-1400SH EM-1600SH EM-2100SH
Max Laminating Width 1200mm 1400mm 1600mm 2100mm
Max Laminating Thickness 25mm
Temperature of Rubber Roller Ambient temperature to 60°C
Approx Highest Line Speed 6m/min
Approx Lowest Line Speed 0.7m/min (adjusting the pressure and speeds)
Rated Working Voltage/Frequency 220V, 50Hz (100V, 60Hz)
Rate Input Power 970W 1310W 1500W
Dimensions 1790 x 650 x
1255
1790 x 650 x
1255
1790 x 650 x
1255
1790 x 650 x
1255
Net Weight 185kg 210kg 245kg 280kg
Easymount Single Heated Roller (SH)
Easymount Cold
Safety Instructions
The Control Panel
To Next Page
Loading...