Vivid V4 - Maintenance of the Gear Box; Maintenance of the Traction Motor

7.2 Maintenance of the Gear Box
1. The clearance for the clutch should be kept between
2-3mm.
2. The friction plate should be changed periodically; the
friction value on one side should not exceed 2mm.
3. Adjust the atness of the platen spring plate (feeling
manually): rst tighten the screws diagonally, use your
hand to check the atness of the spring plate. If not at,
tighten the screws for the non-at part.
4. Change the gear oil inside the gear box periodically (for
new vehicle, change the oil after one month or accumu-
lated running distance exceed 1200kms; change the oil
again two months later, then change the oil every half a
year) The oil type is 85W/90GL.
5. Clean the gear box before changing the oil.
!
WARNING
Never mix dierent oils.
7.3 Maintenance of the Traction Motor
1. This traction motor is designed to use at the sea level not
beyond 1200 meters and in a temperature between -25
0
C
and 40
0
C.
2. Always insure proper battery voltage.
3. Never keep the motor running idly.
4. Never store or operate near combustible fuels.
5. Any mud, sand and other clinging objects shall often be
cleaned away so as to provide good heat-radiation.
20