Vivid V4 - User Manual

Questions and Answers

V
Veronica LongAug 2, 2025
What to do if my Vivid Electric Vehicle doesn’t move?
- M
  Melissa GoodwinAug 2, 2025
  If your Vivid Electric Vehicle isn't moving, several issues could be the cause. Check the following: * Ensure all connectors in the circuit are tight and properly connected. * Replace any blown fuses in the controller or main circuit. * Tighten or replace loose or disconnected battery cables. * Replace a broken power key or voltmeter. * Adjust battery terminals if they connect improperly. * Operate the vehicle following the correct procedure. * Check or replace the controller or solenoid if they have failed.
A
Ashley FlowersAug 7, 2025
Why is my Vivid Electric Vehicle losing control and speed cannot be adjusted?
- A
  Abigail WeissAug 7, 2025
  If you are losing control of your Vivid Electric Vehicle and the speed cannot be adjusted, the possible causes are: * Terminals of the solenoid stick together: check and repair. * Controller failure: replace the controller. * Potentiometer failure: repair or replace the potentiometer. * Internal short of motor: repair or replace the motor. * Motor assembled too tight or blocked: repair or replace. * Accelerator Failure: repair or replace the accelerator. * Normal at low speed Weak power at high speed: check and change.
B
bfrancoAug 11, 2025
What to do if brakes fail on Vivid Electric Vehicle?
- C
  cortizAug 11, 2025
  If the brakes on your Vivid Electric Vehicle fail, consider these potential causes: * Check for damage or leaks in the master cylinder or wheel cylinder and replace if necessary. * Add brake fluid if the level is insufficient or empty. * Bleed the oil pipe to remove any air that has entered. * Adjust the free travel of the brake pedal if it is too long, or adjust the arrester clearance if it is too big. * Replace worn or distorted brake drums. * Replace the master cylinder if it is leaking oil internally.
J
Jason BishopAug 15, 2025
Why is my Vivid Electric Vehicle steering unstable?
- N
  Nicole PetersonAug 16, 2025
  If your Vivid Electric Vehicle has unstable steering, with the wheels 'flirting,' the following could be the reasons: * The rack of the redirector is worn out: replace the redirector. * The screw plug of the redirector is too tight: adjust it. * The toe-in is adjusted improperly: adjust it. * The bearing of the front wheel is worn out: replace it. * The tie rod ball and joint are worn out: replace the tie rod. * The redirector is loose: tighten it.
K
kevinwolfAug 25, 2025
Why Vivid Electric Vehicle cannot change direction?
- M
  morgansarahAug 25, 2025
  If your Vivid Electric Vehicle cannot change direction, it might be because of: * A faulty F&R switch: replace the switch. * Controller failure: replace the controller.
X
xphillipsAug 28, 2025
What causes hard gear shifting in Vivid Electric Vehicles?
- M
  Monique ClementsAug 28, 2025
  If you're experiencing difficulty shifting gears or the gear shift jumps positions in your Vivid Electric Vehicle, consider the following: * Clutch cannot separate smoothly: adjust it. * Gear shift tightwire damage: change it. * Gear inside transmission case wear out: change it. * Orientation pin loosen: change it. * Pressure of front tire is deficient: Check the pressure and inflate. * Screw plug of Redirector is too tight: adjust it. * Lack of lube in redirector: Maintain, add lube. * Toe-in abnormal: adjust it. * Clearance of tension rod ball is too big: change it. * Steering knuckle and master pin is not lubricating: Add Lube.
J
Jennifer WalkerSep 10, 2025
How to fix abnormal sound when Vivid Electric Vehicle is running?
- A
  Alexandra GarrettSep 12, 2025
  If your Vivid Electric Vehicle makes an abnormal sound while running, it could be due to: * Clearance of rear axle decelerating gear is too big, or the decelerating gear is broken: adjust or change the gear. * Transmission cross shaft wear out: replace the shaft. * Gear of transmission wear out or damage: replace the gear. * Flange bearing damage: replace the bearing. * Motor bearing damage: replace the bearing. * Gear liquid is deficient or empty: add gear liquid.