CLEANING MAINTENANCE
TRANSDUCER AND MACHINE BASE DESCALING
Clean the water tank and sink every week, and unplug the power plugbefore cleaning.
External cleaning: wipe the external surface with a clean soft cloth cooler than 40°C.
Do not use hard cleaning tools to avoid damaging parts.
Do not use chemical detergents to clean.
Always replace the water in the water tank to keep the inside of the humidifier clean.
When not in use for a long time, please keep the inside of the humidifier dry.
Before cleaning, make sure to turn o the power and unplug the power plug.
Pour the disincrustant into the base, and then add warm (about 60°C) water to make
the disincrustant dissolve. Let soak for 510 minutes.
Use a cleaning brush to scrub the surface of the transducer until the scale is removed.
At the same time, clean the base and the surface of the machine with clean water.
1.
2.
3.
4.
5.
6.
If your humidifier is not working properly, please check below before requesting service.
After the above treatment, if the machine still does not function normally, please contact
the company's after-sales service center or local dealer. We will do everything we can
to help you.
TROUBLE SHOOTING METHODS
Problem Potential Cause Potential Solution
Abnormal noise Water tank is resonating
with the countertop
Fill the tank with water to
the appropriate level and
keep on a solid surface
The screen shows that there
is water in the tank, but
displays water shortage,
and the status " Icon alarm"
The switch senses that the
float is stuck
Move the float up and
down smoothly
Nothing displays on the
screen
The power is not connected
or switch is not turned on
Connect the power and
switch to "on"
Flashing red light on display
screen and no spray
Low water level Add the appropriate amount
to the tank
The machine powers on
but does not spray
1. The atomizer scales
2. The water is dirty or has
been stored for a long time
3. The amount of fog is set
at the minimum level
1. Clean atomization sheet
2. Add a small amount of hot
water to the tank
3. Replace with clean water
4. Set to the fog level until
desired amount is put forth
6L ULTRASONIC HUMIDIFIER
ASSEMBLY INSTRUCTONS
8
6L ULTRASONIC HUMIDIFIER
ASSEMBLY INSTRUCTONS
7
To Next Page
Loading...