VIVOTEK
6 - User's Manual
Hardware Installation
1. Jot down the camera's MAC address for later reference. This is important if you have
multiple cameras at different installation sites.
2. Attach the alignment sticker to a preferred location. Drill a cabling hole and the pilot
holes for the mounting screws. You can then hammer in the plastic anchors.
Network Camera
Model No: XXXXXX
MAC: 0002D1083236
Pat. 6,930,709
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Made in Taiwan
1
To Next Page
Loading...
