Vivotek IB9365-EHT - Page 373

VIVOTEK
User's Manual - 373
"capability_peripheral_c<0~(n-1)>_washer_mod
e"
washer_status N/A Get the current status of washer control module.
The status is 'off' as default, which means the
washer is stopped; and the status 'on' means the
washer is running.
*Only available when
capability_peripheral_c<0~(n-1)>_washer_supp
ort=1
washer_dwelltime N/A Get the current washer clean period of washer
control system.
*Only available when
capability_peripheral_c<0~(n-1)>_washer_supp
ort=1
heater_supportstatus N/A Get the support status of heater control system.
*Only available when
capability_peripheral_c<0~(n-1)>_heater_suppo
rt=1
heater_status N/A Get the current heater status.
Normally it will be 'auto', it means the heater
device is control by internal algorithm to keep in a
suitable environment; Otherwise is 'trigger', it
means the heater device is force enable to heat to
an internal condition.‘trigger’ status will be
transfer to ‘auto’ after reach the internal condition.
*Only available when
capability_peripheral_c<0~(n-1)>_heater_suppo
rt=1