Vivotek IB9365-EHT - Page 372

VIVOTEK
372 - User's Manual
capability_peripheral_c<0~(n-1)>_heater_suppo
rt=1
trigger heater component is work in force heater once.
*Only available when
capability_peripheral_c<0~(n-1)>_heater_suppo
rt=1
Syntax: (for querying API)
http://<servername>/cgi-bin/admin/peripheral.cgi?channel=<value>&operation=get
[&supportdevice] –Get support peripheral device
[&washer_supportmode] – Get washer support modes
[&washer_mode] – Get washer mode
[&washer_status] – Get washer status
[&washer_dwelltime] – Get washer clean time
[&heater_supportstatus] – Get heater support control status
[&heater_status] – Get heater status
Example:
http://myserver/cgi-bin/admin/peripheral.cgi?channel=0&operation=get&supportdevice&washer_status
Response:
HTTP/1.0 200 OK\r\n
Cache-control: no-cache\r\n
Pragma: no-cache\r\n
\r\n
supportdevice=washer,heater\r\n
washer_status=off\r\n
PARAMETER VALUE DESCRIPTION
channel 0~"capability_nvideoin"-1 Channel of the video source.
supportdevice N/A Get support peripheral device.
washer_supportmode N/A Get the support mode of washer control system,
its value is the same with "capability_peripheral_
c<0~(n-1)>_washer_mode".
*Only available when
capability_peripheral_c<0~(n-1)>_washer_supp
ort=1
washer_mode N/A Get the current mode of washer control system.
It return the value of "washer_mode"
* Available values are listed in