Vivotek IB9367-EHT-v2 - Page 286

VIVOTEK
286 - User's Manual
© 2020 VIVOTEK INC. All Right Reserved
147
NAME VALUE SECURITY
(get/set)
DESCRIPTION
tunnel for UART transfer.
transmission_mod
e
Tx,
Rx,
Both
0/7 Indicate transmission mode of the
machine: TX = server, Rx = receiver
box, Both = DVR.
network_wire <boolean> 0/7 Indicate whether to support Ethernet.
network_wireless <boolean> 0/7 Indicate whether to support wireless.
network_dualmod
e
<boolean> 0/7 Indicate whether network dual mode
is supported.
* Only available when
"capability_network_wireless" is "1".
* We support this parameter when
the version number (httpversion) is
equal or greater than 0305a.
wireless_s802dot1
1b
<boolean> 0/7 Indicate whether to support wireless
802.11b+.
wireless_s802dot1
1g
<boolean> 0/7 Indicate whether to support wireless
802.11g.
wireless_s802dot1
1n
<boolean> 0/7 Indicate whether to support wireless
802.11n.
wireless_begincha
nnel
1 ~ 14 0/7 Indicate the begin channel of wireless
network
wireless_endchann
el
1 ~ 14 0/7 Indicate the end channel of wireless
network
wireless_encrypt_
wep
<boolean> 0/7 Indicate whether to support wireless
WEP.
wireless_encrypt_
wpa
<boolean> 0/7 Indicate whether to support wireless
WPA.
wireless_encrypt_
wpa2
<boolean> 0/7 Indicate whether to support wireless
WPA2.
wireless_apmode_
enable
<boolean> 0/7 Indicate whether wireless AP mode is
supported.
* Only available when
"capability_network_wireless" is "1".
* We support this parameter when
the version number (httpversion) is