Vivotek IP816A-LPC-18 - Page 188

VIVOTEK
188 - User's Manual
7.10 IR cut control
Group: ircutcontrol(capability.nvideoinprofile> 0)
NAME VALUE DEFAULT SECURITY
(get/set)
DESCRIPTION
mode auto,
day,
night,
di0,
di1,
di2,
schedule
auto/di0 6/6 Set IR cut control mode
Note: default value is product
dependent.
HP is auto.
LPC(Parkinglot) is di0.
LPC(Street) is di0.
daymodebegintime 00:00~23:59 07:00 6/6 Day mode begin time
daymodeendtime 00:00~23:59 18:00 6/6 Day mod end time
disableirled <boolean> 0 6/6 Enable/disable built-in IR led
(capability.ir > 0)
enableextled <boolean> 0 1/6 Enable/disable external IR led
(capability.extir > 0)
bwmode <boolean> 1 6/6 Switch to B/W in night mode if
enabled
sensitivity low,
normal,
high
normal 6/6 Sensitivity of light sensor
7.11Image setting per channel
Group: image_c<0~(n-1)> for n channel products
NAME VALUE DEFAULT SECURITY
(get/set)
DESCRIPTION
brightness -5~5,100 100 4/4 Adjust brightness of image according to
mode settings.
saturation -5~5,100 100 4/4 Adjust saturation of image according to
mode settings.
contrast -5~5,100 100 4/4 Adjust contrast of image according to
mode settings.
sharpness -3~3,100 100 4/4 Adjust sharpness of image according to
mode settings.
brightnesspercent 0~100 0 4/4 Adjust brightnesspercent of image