VIVOTEK
User's Manual - 7
Installation
Hardware Installation
1. Loose the waterproof connector, then remove the rubber.
2. Loose the back cover.
3. Tear down the aluminum foil vacuum bag and take out the silica gel. Attach the supplied silica
gel to the inner side of the Network Camera. (Please replace the silica gel with a new one if
you open the back cover after installation.)
4. Make sure all cable lines are securely connected.
5. Tighten the back cover, rubber and waterproof connector.
6. Secure the Network Camera to the wall/ceiling by the supplied camera stand.
3
Silica gel
6
5
1
2
Ceiling Mount
Wall Mount
To Next Page
Loading...
