Vivotek IP8355EH - Page 177

VIVOTEK
User's Manual - 177
0: support only
/cgi-bin/viewer/camctrl.cgi
uart_httptunnel <boolean> 0 0/7 Indicate whether to support
HTTP tunnel for UART transfer.
transmission_mode Tx,
Rx,
Both
Tx 0/7 Indicate transmission mode of
the machine: TX = server, Rx =
receiver box, Both = DVR.
network_wire <boolean> 1 0/7 Indicate whether to support
Ethernet.
network_wireless <boolean> 0 0/7 Indicate whether to support
wireless.
wireless_s802dot11b <boolean> 0 0/7 Indicate whether to support
wireless 802.11b+.
wireless_s802dot11g <boolean> 0 0/7 Indicate whether to support
wireless 802.11g.
wireless_s802dot11n <boolean> 0 0/7 Indicate whether to support
wireless 802.11n.
wireless_beginchann
el
1 ~ 14 N/A 0/7 Indicate the begin channel of
wireless network
wireless_endchannel 1 ~ 14 N/A 0/7 Indicate the end channel of
wireless network
wireless_encrypt_we
p
<boolean> 0 0/7 Indicate whether to support
wireless WEP.
wireless_encrypt_wp
a
<boolean> 0 0/7 Indicate whether to support
wireless WPA.
wireless_encrypt_wp
a2
<boolean> 0 0/7 Indicate whether to support
wireless WPA2.
derivative_brand <boolean> 1 0/7 Indicate whether to support the
upgrade function for the
derivative brand. For example, if
the value is true, the VVTK
product can be upgraded to
VVXX. (TCVV<->TCXX is
excepted)
npreset 0, <positive integer> 20 0/7 Number of preset locations
eptz 0, <positive integer> 3 0/7 A 32-bit integer, each bit can be
set separately as follows:
Bit 0 => stream 1 supports ePTZ
or not.