Vivotek MD8563-EHF4 - Page 229

VIVOTEK
User's Manual - 229
maxpanangle <integer> 0/7 The upper limit for pan angle.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
tiltspeedlv 0, <positive integer> 0/7 The maximum speed level of tilt motion.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
mintilt 0, <positive integer> 0/7 The lower limit for tilt position.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
maxtilt 0, <positive integer> 0/7 The upper limit for tilt position.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
mintiltangle <integer> 0/7 The lower limit for tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
maxtiltangle <integer> 0/7 The upper limit for tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
zoomspeedlv 0, <positive integer> 0/7 The maximum speed level of zoom motion.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoommodule"
is "1"
minzoom 0, <positive integer> 0/7 The lower limit for zoom position.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoommodule"
is "1"
maxzoom 0, <positive integer> 0/7 The upper limit for zoom position.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoommodule"
is "1"
maxdzoom 0, <positive integer> 0/7 The upper limit for digital zoom position.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoommodule"
is "1"