Vivotek VS8100 - Page 128

VIVOTEK
128 - User's Manual
s<0~(m-1)>_mjpeg_bitrate 1000~800000
0
6000000 4/4 Set bit rate in bps when
choosing cbr in
“ratecontrolmode”.
s<0~(m-1)>_forcei 1 N/A 7/6 Force I frame.
7.7 image setting per channel
Group: image_c<0~(n-1)> for n channel products
NAME VALUE DEFAULT SECURITY
(get/set)
DESCRIPTION
brightness -5 ~ 5,100 100 4/4 Adjust brightness of image
according to mode settings.
saturation -5 ~ 5,100 100 4/4 Adjust saturation of image
according to mode settings.
contrast -5 ~ 5,100 100 4/4 Adjust contrast of image according
to mode settings.
sharpness -3 ~ 3,100 100 4/4 Adjust sharpness of image
according to mode settings.
brightnesspercent 0 ~ 100 50 4/4 Adjust brightness of image by
percentage.
Darker 0 <-> 100 Brighter
saturationpercent 0 ~ 100 50 4/4 Adjust saturation of image by
percentage.
Less 0 <-> 100 More saturation
contrastpercent 0 ~ 100 50 4/4 Adjust contrast of image by
percentage.
Less 0 <-> 100 More contrast
sharpnesspercent 0~100 50 4/4 Adjust sharpness of image by
percentage.
Softer 0 <-> 100 Sharper
IBPE_nrenable <boolean> 0 4/4 Enable noise reduction.
IBPE_nrstrength 0 ~ 100 5 4/4 Adjust noise reduction strength. 0
is minimum and 100 is maximum.
xoffset 0 ~ 100 13 4/4 Change start point of input image
in horizontal.
deinterlace_enable <boolean> 1 4/4 Enable de-interlace. This is
enabled by default.
deinterlace_mode adaptive, adaptive 4/4 Adaptive: Detect moving area and