3
If the TV Signal channel scan screen appears, the
TV will need to scan for channels, which takes
several minutes.
Use the arrow buttons on the remote to highlight
Begin Scan and press OK.
10
Otherwise, use the Arrow and OK buttons on
the remote to select the input your TV source
is connected to.
When you are nished, the message
“Setup is complete.” will appear.
The First-Time Setup is complete.
Use the Arrow buttons on the remote to highlight
your TV source and press OK.
9
If you have cable TV, select whether you have
a cable box or if you connect the TV directly
to a cable from the wall.
Note: Number of ports may differ by TV.
21
To Next Page
Loading...
Need help?
General
