3
ADJUSTING THE NETWORK SETTINGS
Your TV is Internet-ready, featuring both an Ethernet port and
built-in high-speed Wireless-N.
Connecting to a Wireless Network
To connect to a wireless network
whose network name (SSID) is being
broadcast:
1. Press the Menu button on the
remote. The on-screen menu is
displayed.
2. Use the Arrow buttons on the
remote to highlight Network and
press OK. The NETWORK menu is
displayed.
3. If you do not see your wireless
network displayed, highlight More
Access Points and press OK. The
WIRELESS ACCESS POINTS menu,
which is a list of available wireless
networks, is displayed.
4. Highlight the name of your
wireless network (this is the
network’s SSID) and press OK.
5. Using the on-screeen keyboard,
enter your network’s password,
then highlight Connect and press
OK.
6. Press the Exit button on the
remote.
If your TV is connected to a network with an Ethernet
cable, you will not see the wireless network connection
menu. You must unplug the Ethernet cable to set a
wireless network connection.
Network
Wired Connection Disconnected
Wireless Access Points
Manual Setup
Hidden Network
Test Connection
Press OK to select your wireless access point.
Back
Changing the Manual Setup Settings
Advanced users can ne-tune the network settings using the Manual
Setup feature.
To change advanced network settings:
1. From the NETWORK menu,
highlight Manual Setup and press
OK. The MANUAL SETUP menu is
displayed.
2. To change the settings manually,
use the Arrow buttons on the
remote to highlight DHCP and then
use the Left/Right Arrow buttons to
change the setting to O.
3. Use the Arrow and OK buttons to
adjust each setting:
• IP Address - The IP address
assigned to the TV.
• Subnet Mask - The subnet Exit 2D
• Default Gateway - Your network’s
default gateway address.
• Pref. DNS Server - Your preferred domain name server
address.
• Alt. DNS Server - Your alternate domain name server address.
4. Use the Arrow buttons on the remote to highlight Save and press
OK.
5. Press the Exit button on the remote.
Manual Setup
DHCP Off
IP Address __.__.__.__
Subnet Mask __.__.__.__
Default Gateway __.__.__.__
Pref. DNS Server __.__.__.__
Alt. DNS Server __.__.__.__
RJ45 MAC 0:0:0:0:0:0
Wireless MAC 0:0:0:0:0:0
Save
Cancel
Back
Finding MAC Addresses for Network Setup
The security settings on your router may require you to enter the
TV’s MAC address in the router’s settings.
To nd the TV’s MAC address:
1. From the NETWORK menu, highlight Manual Setup and press OK.
The MANUAL SETUP menu is displayed.
2. Find the MAC address for the TV at the bottom of the list. The MAC
addresses for the connections in use are displayed:
• RJ45 MAC - The Ethernet or RJ45 MAC address may be
needed to set up your network when you have connected
the TV to your network when you have connected the TV to
your network with an Ethernet (Cat 5) cable.
• Wireless MAC - The Wireless (WiFi) MAC address may be
needed to connect your TV to your network with WiFi.
22
To Next Page
Loading...
Need help?
General
