Vizio VW32L HDTV40A - Page 65

\/12306 IVWSEL HDTVMJA User Manual
.«:;..:a TR} and Sirarxd 7£3as»t.=.> fiaaemtxag
if the originat instructions had been mispiacad or lost, the fcilcwing steps are a dupticate cf such
document, removing the Stand Base may be the oniy steps :0 be done a: this point.
NOTE: Itls stxongly recommended thattwo people perform the setup and assembly due to the
weight and size of the TV. ~
To unpack the TV and same! base
The fonowing steps are required to assembie the have parts: 7 Stand Neck
1. Remove the remote control, batteries. and power
cord from the foam and caps.
2. Remove the two tap foam end caps.
3. Remove the stand base under foam and cap.
4. Remove the TV fmm the box andiay it face down on a ciean, flat surface.
Note: Make sure that the surface is free 0? debris to prevent the TV screen from getting scratched.
Stand Base
To attach the ‘N stand base:
fl. Line up the arrows on the stand neck (attached
to the TV) with the arrows an the stand base.
2. Push the stand base onto the stand neck um?!
you hear them dick together, 7
3. On the bottom of the base, insert the four
induded screws and tighten them up.
4. Move the TV into an upright position.
To remove the stand base
1. Remove the four screws from the stand base. L
2. Puli the,st'and hase away from the stand neck.
Versicn 811822008 L 65 L A
V www.VIZlO.¢om W V A
vxzssv 0011399