BK AV
FEATURES
PARTS LIST
BK 4AV
SAFETY INSTRUCTIONS
V
INSTALLATION
-4
OPERATING INSTRUCTION
VIZIT
-1
13
1
30
is intended for operation in video doorphones as
commutation device between the doorstation and subscriber handsets
--4
-
.
with
a / control unit devices (monitors and apartment
UKP). The device is also applied to connect monitors to the video line.
Simple apartment number coding similar to BK MV
Enhanced noise resistance for video signal distribution
Commutator pc.
Jumpers pcs.
Operating instruction pc.
The device does not contain voltage above
Do not make any connections or repair when the power is on.
Commutator the device hereinafter
The device is recommended for use with monitors powered from individual switching adaptors.
for the device shall be carried out to remove voltage from terminals of the
device, which appears due to leakage current flowing from mains-operated switching adaptors that supply monitors
connected to the device.
is performed following the instructions given in the sections and
.
Before getting started, make sure that all monitors are disconnected from the mains V
()
~ 220 .
Caution. Protective earthing connection
Protective earthing connection CONNECTIONS
EXAMPLE OF WIRING DIAGRAMS
For qualified installation, wiring and servicing refer to technical and commercial partners of VIZIT TM. The list of
companies is given on VIZIT.EU ( .http://vizit.eu/eurounion/)
BK AV-4
-
-
-
Drill two holes in a wall, with
diameter mm and depth mm
Drive anchors (2) into the holes
(1)
630.
6х30 .
.
Fix the device by fastening 2 screws 25
in the anchors
3.5х (3)
(1) - DIN- 35 1-2
(2) - -
rail, width mm, depth mm
Holder for fixing on a DIN rail
1
2
1
2
3
Figure1 - Mounting on a wall
Figure 2 - Mounting on a DIN-rail
Note. Fasteners are not supplied.
www.vizit-group.com BK-4AV Operating Instruction (revision 6 12201 - ) 1/6
To Next Page
Need help?
General
