Vjoycar TK05 - Change Device Password; Motion Detection Alerts; Vibration Sensitivity Settings; SMS or Call Alert Configuration

!
!
!
!
5.3 Changing the Password:
SMS: *password*654321* (654321 refers to new password)
You will receive the following text: "Notice: The password change is
successful for +1XXXXXXXXXX. The new password is 654321.”
!
Note: Changing password command has to be sent from master controller
number.
!
!
6. Motion Detected Alert
The Master Controller will receive an alert (call or SMS) once the device
detects vibration indictaing possible motion.
!
6.1 Vibration sensitivity:
The device you have purchased is equipped with a sensitive Vibration
detection system. The motion sensor sensitivity rate can be set by SMS
command.
!
SMS: *sensitive*1-5* (where X = 1-5, 1 being the most sensitive, 5 the
least, default setting is 1)
1=3seconds continued vibrating
5=15seconds continued vibrating
!
!
Device Response: “Notice: Vibration sensitivity is set to 1-5.”
!
6.2 SMS or CALL Alert Settings:
With the vibration detection system. There will be a Call alert (call master
number 2 times) or a SMS alert generated and send to master number, when
any motion is detected after 3 minutes of non-movement. The system
default setting is call alert, and can be turned off by SMS command
!
SMS: *alertoff*
Device Response: “Notice: System has ended alert function.”
SMS: *smsalert*
Device Response: “Notice: System has entered SMS alert function.”
SMS: *callalert*
Device Response: “Notice: System has entered call alert function.”
!
!
!
!
!
!