VLX 416S - User Manual

1
416S Walk-Behind Micro Scubber Quick Guide
This guide is intended for quick consultation only and does not replace the Use and
Maintenance Operator Manual. R
ead the Use and Maintenance Operator Manual completely
and understand the machine before operating.
Operator video available online at VLXclean.com. For technical support, call 800-861-7352.
PREPARATION/OPERATION
1. Fill the solution tank. 5. Press the ON button.
6. Press the brush button to
activate suction and water
delivery. All lights should be
illuminated green.
7. Press and hold the levers to
engage brush and water flow.
8. Dry sweep before cleaning.
9. Begin using machine. When you
have finished cleaning, proceed as
follows:
• Press the brush button.
• Turn the machine off by pressing the
ON button for at least 4 seconds.
• Raise the squeegee.
• Close the detergent tank tap.
• If necessary, charge the batteries
(BATTERY VERSION)
2. Adjust the angle of the handle by
pulling the handle release lever.
3. Lower the squeegee using the lever.
4. Open the solution tank tap.
10. DAILY MAINTENANCE
Drain the dirty water tank.
11. Clean the dirty water tank.
©Tennant Company. Specifications subject to change without notice
416S Wall Chart 8/18

Summary

Machine Preparation and Operation

Prepare the Machine for Use

Fill the solution tank, adjust the handle, lower the squeegee, and open the solution tank tap.

Start and Conduct Cleaning

Power on the machine, activate functions, perform dry sweep, and begin cleaning operations.

Machine Shutdown Procedure

Steps to stop the brush, turn off the machine, raise the squeegee, and close the detergent tap.

Daily Maintenance

Drain and Clean Dirty Water Tank

Drain the dirty water tank and clean it thoroughly after daily use.

Check Solution Filter and Squeegee

Inspect the solution line filter and clean the squeegee for optimal performance.

Clean the Brush

Remove and clean the brush to ensure effective scrubbing.

Troubleshooting Common Issues

Machine Not Starting

Check battery charge, power cable connection, and socket functionality.

Machine Leaves Floor Wet

Verify squeegee blades, debris in squeegee, suction hose, and dirty water tank status.

Machine Leaves Floor Dirty

Check brush suitability, floor sweeping, debris between squeegees, and squeegee wear.

VLX 416S Specifications

General

Model	VLX 416S
Category	Scrubber
Type	Walk-behind
Working Width	16 in (41 cm)
Recovery Tank	12 gal (45 L)
Power Source	Battery
Brush Width	16 in (41 cm)
Solution Tank Capacity	11 gal (41 L)
Recovery Tank Capacity	12 gal (45 L)