EasyManua.ls Logo

VM EMOVE RoadRunner Pro - Install the Foot Pegs; How to Remove;Replace the Battery

VM EMOVE RoadRunner Pro
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11. Using the multitool, check the screws for the throttle, brake levers, and button
consoles to make sure they are secure and the components are in the position
that you like for riding.
12. Remove protective coverings from the display and seat.
Install the Foot Pegs
1. Locate the foot pegs (2). Find the bolt and nut on either side of the frame.
2. Remove the locking plate from the pegs by removing the two screws.
3. Loosen the nut and remove the locking pin (this can be thrown away), and slide
the foot peg over the peg axel.
4. The foot peg should be attached so that it folds up at the joint (not down).
5. Put the nut on and tighten in place.
a. Note: you may need a secondary 14mm wrench to to tighten the nuts in place.
6. Take the locking plate and install it on the peg, like it was originally from the box.
7. Repeat the process on the other side.
How to Remove/Replace the Battery
1. First, locate the battery (with keys) in the center of the frame.
2. Unlatch the locking pin to unlock the top battery door. Make sure the door is clear
of the battery, so you can slide it free.
3. Grab the battery by the handle and brace your other hand on the scooter for
leverage.
4. Slide the battery on the track and out through the back to remove it from the
scooter.
5. Lock the locking mechanism.
a. Note: this will be tight the first few times until it settles with the battery.
6. To replace the battery, reverse the process.
7. When sliding onto the track, make sure the battery is fully seated against the plug
at the bottom.
8. The top battery tray should snug up against the battery.
9. Use the keys to lock it in place.
a. NOTE: The keys secure the battery in place and do not act as a security measure for
the entire scooter (no alarm or electrical features). The keys are scooter/battery
specific; if you purchase a spare battery, you’ll have two unique sets of keys.
b. Please take care of the keys as we will not be providing any duplicate keys. If you
are extra cautious, please have spare keys made post-purchase to ensure that
you have a spare.
Distributed by and property of VoroMotors 5