VMAI V8 Pro - Cleaner Operation Details; Switching Modes and Spraying; Cleaning Technique and Tips; Dirty Water Tank Maintenance

Switch Button
Max Mode
Spray Button
Voice Switch
****** Important tips:
• Please choose the hard roller brush for areas with a short rug.
Backward
forward
****** Important tips:
• Please DO NOT run over the edges of the rugs.
• The dirty Water Tank must be cleaned as soon as the cleaning work finished, or it will
be stinky.
7. Please clean the dirty water tank after each use of cleaning.
10
2. Press the switch button on the handle to turn on the cleaner. Press the Max Mode
button to switch the suction power.
• Please DO NOT use cleaner in the LONG rug areas.
• Please DO NOT use cleaner in the delicate rugs, silk, or similar floors.
• Please DO NOT SPRAY on the rugs.
4. Hold the spray button for 8 seconds to prime the cleaning water/solutions before each
use. Spray the water according to your personal use during the cleaning.
3. There will be Voice Assistance providing operation support. This function can be
switched off by pressing the voice switch button.
5. Hold the handle and pull the cleaner forward and backward to clean your floors.
6. The angle range of handle tilt must be within 60.5 degree(up and down), please do not
shake it in use.
60.5°
• DO NOT turn the main body over before cleaning the dirty water tank, or the dirty
water will flow into the vacuum motor and damage cleaner.
.