The voice engine says, "Current operator is (operator name). Select menu item."
3. Tap the + button or — button on the device screen until the voice engine says, "Change
task." Then, tap the operator button.
4. The voice engine says, "Please wait. Loading task list." This may take a few moments.
Note: While the voice engine retrieves the task list, the status indicator blinks
red. If the process takes more than six seconds, the voice engine will beep to let
you know the system is trying to complete an action.
If the task list is not found, the terminal says, "No task list found" and goes to sleep.
If a task list is found, the voice engine then says, "Current task is (task name). Select
task."
5. Tap the +/— buttons until you hear the name of the task that you want to use.
Note: At this point you can exit from the menu without loading the new task by
pressing the yellow play/pause button.
6. Tap the operator button to select the particular task.
The voice engine says, "Preparing for task load."
As the task loads, the voice engine says, "Loading task."
When the task is loaded, the voice engine says, "Task load complete."
To Next Page
Loading...