10
Transportation,
Storage and
Handling
• Remove the temporary protections and visually check the condition of all the elements.
• If the pump has been stored and/or stopped for a long period of time (more than 6 months), it is necessary to renew
the lubrication of the motor bearings as indicated in the motor manual.
• After a short storage period, it is sufficient to manually rotate the pump shaft to unlock the rotor assembly.
• Review and apply the short-term storage instructions specified in the manuals for the motor and other items used.
• Observe the other steps listed in the "Start-up" section.
If the equipment is going to be stopped for a certain period of time and there is danger of frost, it is necessary to drain the
pump completely to avoid its deterioration due to the possible freezing of the contained fluid.
Transportation, Storage and Handling
4.3.2 After Storage
To Next Page
Loading...