Need help?Do you have a question about the Voice Systems eclipse sub and is the answer not in the manual?
General| Brand | Voice Systems |
|---|---|
| Model | eclipse sub |
| Category | Subwoofer |
| Language | English |
Features a forced cooling system for the internal amplifier, enhancing performance and cooling.
Specifies the custom-designed 12-inch speaker used in the subwoofer.
Describes the cabinet made with HDPE technology for robustness, light weight, and ease of transport.
Explains the Multicomp circuitry for progressive signal compression, avoiding harsh cuts.
Details the Antidump stage that prevents impulsive noises damaging the drivers.
Explains the function of the Multicomp insert key for disabling the controller.
Describes the Clip LED indicating compressor activity and the green LED for audio signal presence.
Explains the GND Lift key for splitting chassis ground from signal ground.
Details the Boost control for enhancing low-end response via EQ circuitry.
Identifies the Level control as the volume control.
Selects working mode (Stereo/Mono) for connecting speakers and mixer cables.
Inverts signal phase to improve low-frequency efficiency if phase reversal is detected.
Describes output filtering (Xover/Flat) for subwoofer and satellite signals.
Describes slots on top for stacking speakers and creating multi-unit systems.
Explains rubber feet for stability and plastic feet for stage monitor use.
Mentions the metal front grid and the blue ON LED on the front panel.
Locates the AC in cable connector with fuse protection on the control panel bottom.
Mentions the power switch located next to the AC IN connector.
Illustrates mixer connections using jack or male XLR plugs.
Shows how to connect ECLIPSE satellites using a female XLR plug.
To Next Page