15
Compact
4.7.3 CONNECTING THE MAINS (230V) INPUT (fig.
14)
The appliance comes with a factory fitted main
electrical supply cable. If it’s necessary to change
the main electrical cable, proceed as follow.
Open the terminal strip cover. Pass the cable
through the cable anchorage. Connect the supply
cable wires (earth, live, and neutral) to their
corresponding terminals on the terminal strip.
Ensure that the EARTH wire is left slightly longer
that the others, this will prevent strain on the
EARTH wire should the cable become taut.
The securing screw on the cable anchorage
should now be tightened. This must be done
before the control fascia is re-fitted in the upright
position. The terminal strip cover can now be re-
fitted.
To Next Page
Loading...
