01-264
Basic setting, initiating
Function 04 "Initiate basic setting" performs
several functions with ABS Mark 60:
Display group number 001 is required only to
bleed the hydraulic system Page 01-266
Note:
The basic setting is only necessary to bleed the
hydraulic unit if at least one chamber of the brake
fluid reservoir has completely run dry.
Display group number 040
1)
is required to shut
off the longitudinal acceleration sensor -G251-
in order to utilize the maximum engine
performance for a test, e.g. on a rolling road
test stand Page 01-269 .
Display group number 060
2)
is required to
perform a zero compensation for steering angle
sensor -G85- Page 01-271 . Subsequently a
test drive must be performed Page 01-284 .
Display group number 063
2)
is required to
perform a zero compensation for sensor for
transverse acceleration -G200- Page 01-
275 . Subsequently a test drive must be
performed Page 01
-284 .
Display group number 066
2)
is required to
perform a zero compensation for Sender 1 for
brake booster -G201- Page 01-278 .
Subsequently a test drive must be performed
Page 01-284 .
Ст
To Next Page
Loading...
Need help?
General
