CONTROLS
AND
EQUIPMENT
Closing windows with automatic
closing function*
Lift and briefly hold the front edge
of
the re-
spective button and window will close fully
(automatic window closing).
If
the
switch
is
pressed again, the window
will stop immediately.
The roll-back function
1
- If
the window in the driver's
or
passen-
ger door
is
hindered whist closing
through stiffness
or
by an obstacle
(roll-
back function),
the
window will open
again immediately.
2
-
After
the
window
has
opened,
you
must lift
and
hold
the
appropriate
switch
for the
window affected again
within 10 seconds.
If
the window is still
hindered whilst closing through stif-
fness
or by an
obstacle,
the
window
will stop closing.
3
-
After
the
window
has
stopped,
you
must lift
and
hold
the
switch again
within
5
seconds
in
order
to
close
the
window.
The window will
now
close with-
out
the
roll-back function
Warning
Careless
or
uncontrolled closing
of
the
windows
can
cause seri-
ous injuries!
Note
If you wait
for
longer than
10 or 5
seconds
between
the
individual steps,
the
window
will open again when the switch is operated
again.
Closing
the
windows without auto-
matic closing function
Lift
the
switch
by the
front edge until
the
window
is
completely closed.
Please note that
the
window closes
without
the
roll-back function.
Warning
Careless
or
uncontrolled closing
of
the
windows
can
cause seri-
ous injuries!
Function
of
the
electric win-
dows with ignition switched
off
After the ignition has been switched off,
the
windows can still be operated for about ten
minutes
so
long as a door
or
the tailgate are
not opened.
Opening
Press and briefly hold
the
front edge
of the
respective button and the window will open
fully (automatic window opening).
If
the
switch
is
pressed again,
the
window
will stop immediately.
46
OPEN
AND
CLOSE
CONTROLS
AND
EQUIPMENT
Closing
Lift
the
switch
by the
front edge until
the
window
is
completely closed. There
is no
automatic closing function.
If the window in the driver's door is hindered
whilst closing through stiffness
or
by an ob-
stacle (roll-back function),
the
window will
open again immediately.
In this case you can only close
the
window
again after
the
ignition
has
been switched
| on.
Note
The automatic opening/closing function*on
the driver's
and
passenger door windows
will
not
function after
the
vehicle battery
has been disconnected/reconnected.
To reinstall this function after reconnecting
the battery, please note
the
following
points.
Switch
on
ignition and open the window
in
the driver's door fully using switch (1). Then
release
the
switch.
Fully close the window
by
lifting the switch
(1).
The
automatic closing
and
opening
function
in the
driver's door
has now
been
reinstalled.
Repeat this procedure for the window in the
passenger door using switch
(2).
OPEN
AND
CLOSE
47
To Next Page
Loading...
