CONTROLS
AND
EQUIPMENT
Sun visors
®J,I
^^^^^^^^^^^^
B1H-052C
|
®J,I
The
sun visors can be pulled out of the side
mountings and swung towards the doors.
The
make-up mirror can also have a sliding
cover
or cover flap.
On
the mirror
with
light* the light can, de-
pending on the vehicle model, be turned on:
Either
by
- Moving the sliding cover, or
- By raising or lowering the sun visor, or
- Lifting the cover flap.
Changing
wiper
blades
Taking
the
wiper
blade
off
• Fold the wiper arm away from the screen
and
position the blade perpendicular to the
wiper arm.
•
Press
the retaining spring in the direction
of arrow A.
• Detach the wiper blade in the direction of
arrow B and then remove from the arm in
the opposite direction.
Securing the
wiper
blade
The
retaining spring must engage audibly in
the wiper arm.
When
fitting
wiper blades
with
moulded
wind deflectors one should ensure
that
the
deflector is pointing downwards.
LIGHTS
AND VISION
CONTROLS
AND
EQUIPMENT
Mirrors
The
mirrors should always be adjusted
properly before moving off so
that
good vi-
sion
to the rear is guaranteed at all times.
Adjusting
exterior
mirrors
Normal
outside
mirrors
are adjusted by
pressing
the edge of the mirror surface.
Outside
mirrors
with
extended
mir-
ror
arms
are adjusted by
tilting
the mirror
surface.
Electrically
adjustable
mirrors*
arc
set
by pressing the edge of the knob A in
the driver's door trim.
By
pressing the two upper buttons L or R
switches
to the
left
or right-hand mirror.
If the electrical control of the mirror fails at
any
time the mirrors can be adjusted man-
ually by pressing on the edge of the mirror
surface.
Note
for vehicles
with
convex or
aspherical
outside
mirrors
*
Convex (curved outwards) mirrors enlarge
the field of view but they make objects look
smaller.
These
mirrors
are
only
of li-
mited
use in
estimating
how far
away
a
following
vehicle
is.
Aspherical exterior mirrors have a mirror
surface
with
different curvature. This wide-
angle
mirror increases the area of vision
even
more so than conventional convex
mirrors.
Their
usefulness is also li-
mited
when
judging
the distance to
vehicles approaching
from
behind.
Adjusting
interior
mirrors
The
lever on the lower edge of the mirror
should
be pointing forwards when the
basic
setting is made.
To
set the anti-dazzle position, pull lever to
the rear.
Please also
refer
to the
further
notes
on
next
page.
LIGHTS
AND VISION
71
To Next Page
Loading...
