CONTROLS
AND
EQUIPMENT
Mirror
heating*
Electrically adjustable mirrors*
are
switched on when
the
ignition and
the
rear
window heating
are
switched
on and the
amount
of
heat
is
regulated automatically
depending on
the
ambient temperature.
The heating
for
the exterior mirror and
the
rear window
is
switched
off
automatically
approximately
5
minutes after the rear
win-
dow heating
has
been switched
on. If
necessary,
the
switch
for
the rear window
heating must be switched
of
and then back
on again.
Folding
exterior
mirrors
in
The outside mirrors can
bo
folded
in.
To
do
this pull mirror housing towards
ve-
hicle until
the
retainer locates.
Notes
• Before putting the vehicle through an au-
tomatic washing plant,
the
mirrors should
be folded
in to
prevent them becoming
damaged.
• These remarks apply only
to
vehicles
with normal outside mirrors. Mirrors on
ex-
tended arms can also
be
folded
in but
they
have
no
detent.
Folding
exterior
mirrors
back
Warning
When folding mirror back
out
en-
sure that
the
fingers
are not
trapped between mirror
and
bracket
-
Danger
of
injury.
Press mirror
in
towards vehicle, press
re-
tainer in (arrow
A)
and fold mirror out.
72
LIGHTS
AND VISION
CONTROLS
AND
EQUIPMENT
Heated
rear
window
Curtains
The heating works only when ignition
is
on.
When heater
is on a
lamp
in the
switch
lights
up.
The heating
for
the exterior mirror and
the
rear window
is
switched
off
automatically
approximately
5
minutes after the rear
win-
dow heating
has
been switched
on. If
necessary,
the
switch
for
the rear window
heating must be switched
of
and then back
on again.
Curtains are available for all windows
in the
Multivan and are stored in the bag provided.
The curtain set consists
of
four parts, which
are buttoned on from inside with press but-
tons:
•
A
short curtain
for
the rear window
• Two
of
the same length for the rear side
windows
•
A
long
one for the
windscreen
and the
two cab side windows. This curtain can
be
additionally secured over the windscreen by
swinging down the two sun visors.
Securing curtains
The press stud base
(A) is
attached
to the
inner
trim.
The closed stud (C) is pressed on
to this base.
If
the
studs
of two
curtains
are to be at-
tached
to
one base (A), first attach the cur-
tain with
an
open curtain stud (B). Then
at-
tach the curtain with
a
closed stud (C).
LIGHTS
AND VISION
73
To Next Page
Loading...
