4.24 Interior and exterior body: inspecting for
corrosion with doors and flaps open
Test locations
♦ Sliding roof frame
♦ Inner and outer door frame
♦ Area around trim strips
♦ Windscreen roof edge
♦ Outer and inner A-pillar
♦ Bonnet
♦ Wheel arches
♦ Inner and outer tailgate
4.25 Poly V-belt: renewing
Procedure
⇒ Rep. gr. 13 ; Cylinder block belt pulley end; Removing and
installing poly V-belt
Note
For technical reasons it is possible that several cross references
are not directed to the correct chapter. In this case select the pro‐
cedure manually in the information.
4.26 Poly V-belt: check condition
Carry out following procedure:
– Remove “bottom” engine compartment cover (noise insula‐
tion) ⇒ page 109 .
– Use a suitable socket to turn the engine at the vibration damp‐
er/belt pulley.
Passat 2011 ➤ , Passat Variant 2011 ➤
Maintenance - Edition 01.2019
4. Descriptions of work: 93
To Next Page
Loading...
Need help?
General
