Volt VSM-2407 - 4 Install Stake; 5 Install Stem to Stake

customersupport@voltlighting.com • 813.978.3700
- 5 -
Install Stake
4
Determine the desired location for
mounting the xture. Hammer the
stake into the ground until the ange
of the stake is ush to grade. To avoid
damage to the stake, place a board
on top of the stake while hammering.
NOTE: If the ground is hard and the
stake is difcult to install, make a
crosscut in the ground using a at
shovel.
Board
Stake
Soil
Ground
Clear away an area in the ground
at the wireway slot on the top
of the stake. Lay the luminaire
pigtail into the wireway slot and
attach the stem onto the stake.
Tighten until snug.
Install Stem to Stake
5
Stem
Stake
Pigtail
Wireway Slot