www.volta.com.tr
18
8. MAINTENANCE AND STORAGE
If the break is too tight, by using an allen wrench, slowly untighten the screw
by turning it in the opposite direction of clockwise.
Shorten the size of the break cable. After that, tighten the tightener.
If you think that the break is too loose, extend the break cable and tighten
the tightener.
If you have problems while turning, tighten the two screws next to the folding
pin with an allen wrench.
If the air pressure of your tyres is low, remove the pressure relief lid first. Inflate
the tyre with your air pump. (Not applicable for filled tyres.)
Disk Brake Setting
Brake Settings
Inflating the Tyres
To Next Page
Loading...
