To Next PageTo Next PageWhat to do if connected devices don't work with my VOLTCRAFT PPS 11810?
If connected consumer devices aren't working with your VOLTCRAFT Power Supply, verify the consumers' technical specifications. Also, ensure that the voltage is set correctly and the polarity is correct.
How to troubleshoot a VOLTCRAFT PPS 11810 that will not turn on?
If your VOLTCRAFT Power Supply won't switch on, check the mains voltage and the mains fuse in the device or the line circuit breaker.
What to do if 'REAR CONTROL' is lit on my VOLTCRAFT Power Supply?
If the “REAR CONTROL” display is lit and the device cannot be operated via the rotary controls on your VOLTCRAFT Power Supply, put the rear “MODE” slider into the “Normal” position.
What does it mean when the 'C.V.' LED is lit on my VOLTCRAFT Power Supply?
If the “C.V.” LED is lit on your VOLTCRAFT Power Supply, it means the power unit is working normally and the output is providing the constant voltage set.
General| Output Voltage | 0 - 18 V |
|---|---|
| Output Current | 0 - 10 A |
| Power Rating | 180 W |
| Number of Outputs | 1 |
| Technology | Linear regulated |
| Voltage Resolution | 10 mV |
| Current Resolution | 10 mA |
| Display | LCD |
| Operating Temperature | 0 °C to 40 °C |
| Voltage Accuracy | 0.5 % + 20 mV |
| Storage Temperature | -10 - 70 °C |
User manual section detailing device operation procedures.
Contact information for technical support and inquiries.
Guidelines for safe handling and use of the device by people and pets.
Additional safety information and precautions for device operation and environment.
Instructions for safely connecting the device's power cable to the mains.
Guidance on proper placement and installation of the power unit.
Overview of the device's operation, system checks, and initial display.
Procedure for setting the output current limit for device and cable protection.
Procedure for adjusting the output voltage using front panel controls.
How to safely connect external devices to the power unit's outputs.
Steps to program user-specific voltage and current values into memory slots.
Procedure to restore factory default voltage and current memory settings.
Steps for preparing the physical connection for external remote control.
Using an external voltage source to control voltage and current settings remotely.
Using an external potentiometer to remotely control voltage and current settings.
Controlling the DC output on/off via an isolated switching contact.
Overview of the PC software interface and fundamental operational steps.
Managing stored voltage and current presets via the software interface.
Viewing real-time and recorded voltage-current charts within the software.
Configuring communication ports, sampling times, and limits in the software.
Explanation of the 'OUP' display indicating over-voltage protection activation.
Explanation of the 'OEP' display indicating overheating protection activation.
Explanation of the 'OLP' display indicating overload protection activation.
Procedure for safely replacing the device's main fuse.
