before connecting it to the power supply and putting it to use. This may take several hours.
b) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the device.
• Maintenance, modications and repairs are to be performed exclusively by an expert or at a
qualied shop.
• If you are not sure about the correct connection or use, or if questions arise which are not
covered by these operating instructions, please do not hesitate to contact our technical sup-
port or another qualied specialist.
Operation
Always turn off the USB device that you want to connect before connecting it to the USB port.
Ensure that the product is connected properly. If it is not connected properly, it may become hot
or cause an electrical shock or re.
Ensure that your device is suitable for the connection ratings of the product (see technical data).
1. Turn off the USB device and connect it to the product. Use a suitable USB cable to connect the device
to the power adapter.
2. Insert the product into a mains socket.
3. The USB device will now charge. If you wish to use the USB device, you may now turn it on. Check the
charging/operating status of your USB device.
4. Turn off your USB device before removing the product from the mains socket.
5. Unplug the product from the mains socket after use.
Maintenance and cleaning
• You do not need to carry out maintenance work on the product. Under no circumstances should you
service any of the components in the interior of the product, therefore never disassemble it.
• Do not immerse the product in water.
• Remove the product from the mains socket and the connected USB device before cleaning.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could damage
the casing or even impair the functioning of the product.
• Use a dry, soft and clean cloth to clean the product.
Disposal
This symbol must appear on any electrical and electronic equipment placed on the EU market.
This symbol indicates that this device should not be disposed of as unsorted municipal waste
at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separate-
ly from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by
the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner,
must be removed by end users from the WEEE in a non-destructive manner before it is handed
over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste.
Conrad provides the following return options free of charge (more details on our website):
• in our Conrad ofces
• at the Conrad collection points
• at the collection points of public waste management authorities or the collection points set up by manu-
facturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries
outside of Germany.
Technical data
a) Data according to EU regulation 2019/1782
Manufacturer Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Commercial registration number HRB 3896
BN 2180898 2180926
Model identier SPS-1000 USB SPS-1000 WH
Input voltage 100 - 240 V/AC
Input AC frequency 60 / 50 Hz
Output voltage 5.0 V/DC
Output current 1.0 A
Output power 5.0 W
Average active efciency 76.1 %
Efciency at low load (10 %) 71.0 %
No-load power consumption 0.06 W
b) Others
Connection ........................................... USB, type A
Protection class .................................... II
Operating conditions ............................. 0 to +25 °C, 20 – 85 % RH (non-condensing)
Storage conditions ................................ -20 to +60 °C, 10 – 90 % RH (non-condensing)
Dimensions (W x H x D) ....................... 40 x 26.5 x 82.3 mm
Weight ..................................................Approx. 38 g
Operating Instructions
USB Power Adaptor
Item No. 2180898 / SPS-1000 USB
Item No. 2180926 / SPS-1000 WH
Intended use
This product is designed to charge and power a USB device. The power consumption of the connected USB
device must not exceed 1 A. The product is protected against overload and short circuits.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use can
cause hazards such as short circuiting, re, electric shock etc. Read the instructions carefully and keep them.
Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names and prod-
uct names are trademarks of their respective owners. All rights reserved.
Delivery content
• USB power adapter • Operating instructions
Up-to-date operating instructions
Download the latest product information at www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in the triangle is used if there is a risk to your health, e.g. due to
an electric shock.
The symbol with the exclamation mark in the triangle is used to indicate important information in
these operating instructions. Always read this information carefully.
This symbol indicates that the product meets the energy efciency requirements for Class VI.
The arrow symbol indicates special information and advice on operation.
Safety instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing
material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, ammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it
from any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can dam-
age the product.
• Also observe the safety and operating instructions of any other devices which are connected
to the product.
• Remove the product from the mains socket and the connected USB device when you are
not using it.
• The product generates heat during use. Ensure that there is sufcient ventilation and do not
cover the product during use.
• Do not use any force when connecting USB plugs. A USB plug can only be inserted into the
USB port in one orientation.
• The mains socket that the device is plugged into must be easily accessible.
• Never connect or disconnect power adapters if your hands are wet.
• Never leave the product and the connected device unattended during use.
• For safety reasons, disconnect the product from the mains socket during storms.
• Only connect the power adapter to a normal mains socket connected to the public supply.
Before plugging in the power adapter, check whether the voltage stated on the power adapter
complies with the voltage of your electricity supplier.
• Never use the product immediately after it has been brought from a cold room into a warm
one. The condensation generated could destroy the product. The plug-in power supply unit
also involves danger to life by electric shock! Allow the product to reach room temperature
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represents the technical status at the time of printing.
Copyright 2023 by Conrad Electronic SE. *2180898_2180926_v3_0223_02_dm_mh_en
To Next Page
Loading...
Need help?
General
