VOLTECH AT3600 USER MANUAL EXECUTE MODE
3. EXECUTE MODE
This is the normal operating mode of the AT3600 when used for production testing of
transformers.
Before you try to use the tester in EXECUTE MODE, make sure that all the
following have been carried out:
• Test programs have been created for the transformers you wish to test.
• Either
The programs are archived in the server, which is connected to the tester and
running, and the tester has been set up to use the Server as the Program Store,
or
The programs have been downloaded into the tester, which has been set up to use
its internal memory as the Program Store.
i
For a reminder of how to set up the tester for operation with a LOCAL or
PROGRAM store, see chapter 2, section 2.3.3 of the quick start tutorial.
• Fixtures have been created for the transformers you wish to test.
Note: If you have a foot switch fitted to the remote port on the tester, usually in
EXECUTE Mode, pressing it will take the same action as pressing the upper
soft key.
For text entry (such as the name of the program, or the serial number of the
transformer under test), you may optionally use a bar-code reader connected
to the tester's rear panel Bar-Code Port.
FRONT PANEL OPERATION VPN 98 - 024 PAGE 6.3.1.
To Next Page
Loading...