PROGRAM MODE VOLTECH AT3600 USER MANUAL
6.2. PROGRAMS
When the tester is set up to use the LOCAL program store, and after you have entered
the part name, it will search for that name in the programs that are stored in its own
non-volatile RAM. To store these programs you must use either the ‘group download’
or 'tester download' features described here.
GROUP DOWNLOAD USING THE SERVER
Before attempting to download a group of programs:
• Ensure that the server software is running on its PC, that the lead is connected
from the tester's server port to the server PC, and that COM port is correctly set
up in the server.
• Also ensure that the group you wish to use has been created within the server.
(From the server top level menu, select ‘Setup’, ‘Groups’ etc - as explained in
chapter 4).
To download a group of programs, at the tester's top-level display, press the
PROGRAM soft-key; and then at the ‘Program Mode’ display, press the soft-key
GROUPS. The next display will then prompt you for the name of the program group
you wish to use:
As with other names, the group name can be typed in from the keyboard, entered
using a bar-code reader connected to the tester’s bar-code port or chosen from a list of
available groups.
After choosing the group to be downloaded, pressing the ENTER soft-key (or ↵ key)
will commence the download and, after a few seconds you will see the following
display:
PAGE 6.6.4. VPN 98 - 024 FRONT PANEL OPERATION
To Next Page
Loading...