VOLTECH AT3600 USER MANUAL INSTALLING THE TESTER
2.3. INSTALLING THE EDITOR SOFTWARE
Connect the tester's auxiliary port to a spare COM port on the PC as shown. The
cable that is used will be determined by the type of PC connector. For most PC’s this
will be a 9-pin female (PC) to 9-pin female (AT3600).
Switch on the power supply to the PC
Before attempting to install the Editor, check that your PC satisfies the following
hardware requirements:
PC Processor 486 or better
Memory 4MB minimum
Hard Disk Space 2MB minimum
Operating system Windows 95 or newer
Supported screen resolutions 640 x 480, 800 x 600
1024 x 768, 1280 x 1024
To install the Editor software, place the AT series CD-ROM supplied with your tester
into the CD-ROM drive of the computer and follow the on-screen instructions.
The set-up program will suggest a directory in which to place the Editor files:
c:\Program Files\Voltech Instruments\Voltech AT Editor
This directory will be created if it does not already exist. If you want to place the
files elsewhere, browse to another directory.
If you have a previous version of the Editor software already installed on your PC,
the procedure outlined above may also be used to install a new version. None of your
program files will be lost. The same Editor program is used for all AT Series testers
(excluding the discontinued AT3500 and AT1000).
GETTING STARTED VPN 98 - 024 PAGE 2.2.3.
To Next Page
Loading...