SCHEMATIC EDITING VOLTECH AT3600 USER MANUAL
2.1. ADDING A TRANSFORMER WINDING
To add a transformer winding onto the screen:
1. Select ‘Add Winding’ from the Schematic menu on the menu bar.
2. Place the winding on the screen:
A selected winding will now be displayed attached to the mouse pointer on the
screen. You must decide which half of the screen to place the winding. On crossing
the mid-point of the screen, the winding is mirrored to face the nearest test nodes.
Click the left mouse button to place the winding.
3. Name the winding terminals:
When the winding is placed, a dialogue box appears prompting you to name both of
the winding’s two terminals.
You may move the cursor focus between the fill-in boxes by using the TAB key or by
pointing and clicking with the mouse.
When both terminals have been named, you should press ENTER on the keyboard or
click on OK with the mouse in the dialogue box.
4. To make a winding with more than two terminals, see Adding a terminal to an
Existing Winding, in section 2.5 of this chapter.
i
NOTE: Terminal names may be between 1 and 6 characters in length, and may
contain any upper case letter or AT Series keyboard character excluding
SPACE.
2.2. CONNECTING THE WINDING TERMINALS TO NODES
To connect the winding terminals to test nodes:
1. Select a terminal to connect with the RIGHT mouse button.
2. Keeping the right button pressed, drag the wire to the selected test node.
When the mouse pointer is over the test node, release the mouse button.
The connection may also be made in reverse by first selecting the test node and then
connecting it to the winding terminal.
PAGE 3.2.2. VPN 98 - 024 TEST PROGRAM EDITOR
To Next Page
Loading...