EasyManuals Logo

Volvo Penta AQ145A User Manual

Volvo Penta AQ145A
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
50
163. Connect the cables to the spark plugs.
164. AQ145. Lay the cover (1) on the heat exchanger
and slide over the rubber ring (2) so that the cover
is held in position. NOTE! The rubber ring is to be
turned with the marking “UP” upwards. Place the
strainer (3) properly cleaned as shown in the pic-
ture. Screw on the cover. NOTE! If the strainer is
incorrectly fitted the cover cannot be screwed in
position.
165. Fit the fuel pump. Use new gaskets. Fit the tensio-
ning bar and the engine mounting with the
bracket for the alternator. Then tighten the alterna-
tor in position and fit and tension the belt so that it
can be depressed approximately 5 mm (0.2 in)
with normal thumb pressure.
166. Fit the starter motor. The main fuse (1) is on the
starter motor’s front bracket. The picture below
shows the USA version.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Volvo Penta AQ145A and is the answer not in the manual?

Volvo Penta AQ145A Specifications

General IconGeneral
Cylinders4
Fuel TypeGasoline
Bore96 mm
Fuel SystemCarbureted
Stroke80 mm
Engine TypeIn-line 4-cylinder
Cooling SystemWater-cooled

Related product manuals