42
Maintenance: Engine
Vibration Damper Inspection
NOTE! When installing a damper protective
cover to the engine, do not use a cover
enclosing the damper.
Visually check for fluid leaks, flaws, distortion, or dis-
coloration or flaking of painted surfaces. Also check
for swelling (by measuring with a scale), and fluid le-
aks past staked portions.
Re-tighten Bolts and Nuts
Re-tighten the bolts and nuts on the following compo-
nents:
* Timing gear case
* Crankshaft pulley
* Mounting brackets
* Exhaust manifold
* Turbocharger
* Cylinder heads
Check the cylinder head bolts and re-tighten them in
number sequence (1-2-3-4-5-6) if necessary. The
tightening torques of the bolts and nuts can be found
in technical data section of this manual.
Plus d'informations sur : www.dbmoteurs.fr
To Next Page