Volvo Penta D30A MS - Page 87

87 pages

Save Page as PDF

To Previous Page

To Previous Page

Loading...

7741946-3 English 04–2002

Plus d'informations sur : www.dbmoteurs.fr

Table of Contents

Foreword3
Table of Contents4
Safety Information6
- Safety Regulations During Engine Operation7
- Safety Directions for Maintenance and Service8
  - Cooling System9
  - Lubricating System9
- Warning Labels D25A / D30A MS10
- Warning Labels D25A / D30A MT11
Introduction12
- Care of the Environment12
- Fuel and Oil12
- Service and Spare Parts12
- Certified Engines13
- Warranty13
Presentation14
- D25A/D30A Ms14
- D25A/D30A Mt15
New Engine Initial Service16
- General16
- External Inspection16
- Valves and Plugs16
- Electrical Wiring16
- Fill Fuel System16
- Fill Lubrication System16
- Fill Cooling System16
Starting17
- Before Starting17
- Warming-Up17
Standard Control System18
- Instrument Panels18
- Warning Displays19
- After an Alarm19
- Alarm Test19
- Starting Switch19
- Starting Procedure20
- Operation21
- Alarms and Fault Indication22
- Stopping the Engine22
- Emergency Stop22
Operation23
- General23
- Applying Load24
- Running in24
- Forced Propeller Rotation24
- Manoeuvring24
- Manual Speed Control25
- Start Using Auxiliary Batteries27
Stopping28
- Manual Stop Lever28
After Stopping29
- General29
- Anti-Freezing Measures29
- Breaks in Operation [Not Using the Engine]29
Maintenance30
- Maintnenance Schedule D25A/D30A MS31
- Maintnenance Schedule D25A/D30A MT34
- Overhaul Information37
- Recommendation of Daily Operation Records39
Engine40
- Valve Clearance40
- Firing Order41
- Vibration Damper Inspection42
- Re-Tighten Bolts and Nuts42
- How to Use the Turning Gear43
Fuel System44
- Fuel System Bleeding44
- Fuel Filter Change46
- Fuel Tank Drain47
- Fuel Injection Nozzle Tip Change47
- Fuel Injection Pressure48
- Injection Timing Inspection50
- Fuel Control51
- Twin Fuel Pre-Filter/Water Separator52
Lubrication System54
- Lubrication Oil Level Check54
- Lubrication Oil Filling54
- Lubrication Oil Change56
- Oil Filter Change57
- Lubrication Oil By-Pass Filter Change58
- Hydraulic Governor Oil Filter Change58
Freshwater System59
- Coolant Level Check59
- Coolant Filling60
- Coolant Drain60
- Freshwater System Flushing61
Seawater System62
- Draining the Seawater System62
- Check and Change the Zinc Anodes62
- Seawater Filter Check/Change62
- Seawater Pump Impeller Check/Hange63
- Heat Exchanger Cleaning63
Air Inlet and Exhaust Systems64
- Turbocharger Inspection64
- Cleaning the Air Cooler64
- Check Air Cooler Drain Pipe64
- Wash the Air Filter65
Electrical System66
- Protective Devices Inspection66
- Check the Electrical Wiring66
- Starter Motor Inspection66
- Alternator Inspection66
- Drive Belts. Check/Adjust/Change66
Inhibiting67
- General67
- Preparation67
- Care During Storage67
- Return the Engine to Service67
- Storage of Engine in Operating Condition68
Troubleshooting69
Technical Data70
- D25A Ms70
- D25A Mt71
- D30A Ms72
- D30A Mt73
- Fuel Specification74
- Lubrication Oil Specification75
- Coolant Specification76
- Tightening Torque Tables77
- Identification Numbers D25A / D30A83
- Sea Trial Data84

Related product manuals

Preview: Volvo Penta D34A MS

Volvo Penta D34A MS

Volvo Penta D25A MS

Preview: Volvo Penta D3

Volvo Penta D3-130A

Volvo Penta D3-160A

Volvo Penta D3-190A

Volvo Penta D3-190i

Volvo Penta D3-110i

Volvo Penta D34A MT

Preview: Volvo Penta D3 290/DP

Volvo Penta D3 290/DP

Preview: Volvo Penta D3-130A-A

Volvo Penta D3-130A-A

Preview: Volvo Penta D2-55

Volvo Penta D2-55