● Transmission Oil Temp
Not used on gas engines
● Engine Hours – Displays the total number of
hours the engine has been operated (h).
● Engine Oil Pressure – Displays engine oil pres-
sure (psi, kPa).
● Rudder Angle – Displays the amount the stern-
drive is off center (°). Optional rudder angle sen-
sor required.
● Turbo Pressure
Not used on gas engines
● Power Trim Angle – Displays the amount of tilt,
up or down, of the sterndrive (°). Also shown as
a popup for two seconds while trimming.
● Coolant Temp – Displays engine coolant tem-
perature (°C, °F).
● Speed – Displays boat speed over the water
(knots, mph, km). Optional multisensor or NMEA
0183/NMEA 2000 compatible component (plot-
ter, GPS, paddle wheel, etc.) required.
● Propeller RPM
Not used on gas engines
● Depth – Displays current depth of the water
under the boat (ft, m). Optional Volvo Penta depth
sounder (multisensor) required.
● Engine RPM – Displays engine speed in revolu-
tions per minute (rpm).
● Water Temp – Displays the temperature of the
water surrounding the boat (°C, °F). Optional
Volvo Penta water temperature sensor (multisen-
sor) required.
● Slip Factor
Not used on gas engines
Settings Menu
In the Settings menu, you may set various options and
calibrate various parameters for the EVC system.
Available option include:
● My View
● Drive Type – OEM/Dealer Only
● Toe Angle – OEM/Dealer Only
● Neutral Beep
● Info Beep Level
● PTA Calibration
● Trip Reset
● Display Contr.
● Side Selection
● Units
● Language
● Log Cal. Factor
● EVC Info
For twin engine installations always perform the set-
tings on the port side system. Port side is the master
side.
When you are in the Settings menu, navigate to a spe-
cific selection. Highlighted selections appear within a
rectangular box. When you have highlighted the option
you wish to modify, press the OK button to enter the
submenu for that selection.
Push the BACK button to return to a previous menu
level at any time.
Instruments and Controls
47701898 12-2010 37
To Next Page
Loading...
