Crank Override Mode
If the drive is in tilt range and the engine must be
started, you may do so by using Crank Override Mode.
When you first try to start the engine with the drives in
the tilt range, you will receive a message that the
engine cannot be started and that trim is too high. Sim-
ply hold the ignition key in the start position for over 5
seconds until the engine starts.
NOTICE! Do not run the engine above idle speed while
the drive is in tilt range.
Power Trim Override Mode
If the drive is tilted to maximum trim range (+30°) and
you wish to raise it further (i.e. for beaching purposes
or in extremely shallow water), you may do so by hold-
ing the trim up/out button for over 5 seconds. The sys-
tem will display a message informing you that you may
override power trim limits. Continuing to hold the trim
up/out button will raise the drive beyond the limits set
by the boat manufacturer. The system will display a
message informing you that trim override has been
activated. You may continue raising the drive until you
have reached the mechanical limit.
NOTICE! If your transom shield/drive package is not
mechanically limited, when applying power trim over-
ride mode, use extreme caution while raising the drive
as there is a possibility of pushing the drive into the
swim platform.
NOTICE! Do not run engine above idle speed when
overriding trim limits set by your boat manufacturer as
it will cause damage to the U-Joint and engine.
Instruments and Controls
47701898 12-2010 47
To Next Page
Loading...
