Power Trim panel
The Power Trim panel allows you to adjust the angle
of the drive with respect to the transom. For twin
engine installations, the power trim panel may be used
to make individual or simultaneous adjustments to the
drives.
By trimming out the drive away from the transom, the
bow will be ”raised” in relation to the horizontal axis
and trimming in the drive will ”lower” the bow of the
boat.
The + button will trim the drive away from the transom
(i.e., the bow will be ”raised” in relation to the horizontal
axis).
The – button will trim the drive in towards the transom
(i.e., ”lower” the bow of the boat).
For further information on power trim, please refer to
Power Trim, Trim Ranges, Power Trim Instruments
and Displays, Power Trim Assistant, and Emergency
Trimming in this chapter.
Instruments and Controls
47701898 12-2010 49
To Next Page
Loading...
